Configuring The Maximum-Call-Connection Set - 3Com MSR 50 Series Configuration Manual

2306 C 133: D
HAPTER IAL
Configuring the
Maximum-Call-Connecti
on Set
P C
LAN ONFIGURATION
[RouterC-voice-dial] entity 1000 pots
[RouterC-voice-dial-entity 1000] match-template 010....
[RouterC-voice-dial-entity 1000] line 1/0
[RouterC-voice-dial-entity 1000] send-number all
[RouterC-voice-dial-entity 1000] quit
[RouterC-voice-dial] entity 1001 pots
[RouterC-voice-dial-entity 1001] match-template 010....
[RouterC-voice-dial-entity 1001] line 1/1
[RouterC-voice-dial-entity 1001] send-number all
[RouterC-voice-dial-entity 1001] quit
# Configure rules in the match order for voice entity selection
[RouterC-voice-dial] select-rule rule-order 1 4
Network requirement
There are one trunking voice gateway (Router C) and two subscriber voice
gateways (Router A and Router B) in a city. To prevent the trunk lines from being
totally occupied by either subscriber voice gateway, you must restrict the number
of calls respectively originated from Router A and Router B.
Network diagram
Figure 669 Network diagram for the maximum-call-connection set configuration
010-1234
PBX
010-1235
Configuration procedure
Configuration on Router A
■
# Configure an Ethernet address.
<RouterA> system-view
[RouterA] interface ethernet 2/0
[RouterA-Ethernet] ip address 1.1.1.1 24
[RouterA-Ethernet] quit
# Configure a VoIP entity.
[RouterA] voice-setup
[RouterA-voice] dial-program
[RouterA-voice-dial] entity 2000 voip
[RouterA-voice-dial-entity 2000] match-template 010....
[RouterA-voice-dial-entity 2000] address ip 1.1.1.3
[RouterA-voice-dial-entity 2000] quit
Eth2/0
1.1.1 .3/24
WAN
Router C
Eth2/0
1.1 .1.1/24
Router A
Eth2 /0
1.1.1 .1/24
Router B
1000
1001
2000
2001