3Com MSR 50 Series Configuration Manual page 1634

1634 C 84: T
HAPTER RAFFIC
C , P ,
LASSIFICATION OLICING AND
To do...
Apply TP policy on the
interface
Display the TP information on
each interface
Configuring traffic policing applicable to all traffics
Follow these steps to configure traffic policing applicable to all traffics
To do...
Enter system view
Enter interface Enter interface
view or port view
group view
Enter port
group view
Apply TP policy on the
interface
Display the TP information on
each interface
The action taken on a packet can be:
continue: Has it to be dealt with by the next CAR policy.
■
discard: Discards the packet.
■
pass: Sends the packet.
■
S
HAPING
Use the command...
qos car { inbound |
outbound } acl [ ipv6 ]
acl-number cir
committed-information-rate
[ cbs committed-burst-size
[ ebs excess-burst-size ] ]
[ green action ] [ red action ]
display qos car interface
[ interface-type
interface-number ]
Use the command...
system-view
interface interface-type
interface-number
port-group aggregation
agg-id
qos car { inbound |
outbound } any cir
committed-information-rate
[ cbs committed-burst-size
[ ebs excess-burst-size ] ]
[ green action ] [ red action ]
display qos car interface
[ interface-type
interface-number ]
Remarks
Required
cbs is half of cir within unit
time by default. If the default
value is lower than 1875,
1875 is taken as the default
value.
ebs is 0 by default.
green action is pass by
default.
red action is discard by
default.
Optional
The display command can be
executed in any view
Remarks
-
Use either command
Configured in interface view,
the setting is effective only on
the current interface;
configured in port group
view, the setting is effective
on all the ports in the current
port group.
For the information about
port group configuration,
refer to "Link Aggregation
Configuration" on page 351.
Required
cbs is half of cir within unit
time by default. If the
counted default value is
smaller than 1875, then 1875
is taken as the default value.
ebs is 0 by default.
green action is pass by
default.
red action is discard by
default.
Optional
The display command can be
executed in any view