Configuration Procedure - 3Com 4500 PWR 26-Port Configuration Manual

Configuration procedure

# Create customer VLANs VLAN 100 an
Switch A.
<SwitchA> system-view
[SwitchA] vlan 100
[SwitchA-vlan100] quit
[SwitchA] vlan 200
[SwitchA-vlan200] quit
[SwitchA] vlan 500
[SwitchA-vlan500] quit
[SwitchA] vlan 600
[SwitchA-vlan600] quit
# Configure Ethernet 1/0/11 of Switch A as a trunk port an
Assign Ethernet 1/0/11 to VLAN 100 and VLAN 500. Configure Ethern
[SwitchA] interface Ethernet 1/
[SwitchA-Ethernet1/0/11] port link-type trunk
[SwitchA-Ethernet1/0/11] port trunk pvid vlan 100
[SwitchA-Ethernet1/0/11] port trunk permit vlan 100 500
[SwitchA-Ethernet1/0/11] quit
[SwitchA] interface Ethernet 1/0/12
[SwitchA-Ethernet1/0/12] port link-type trunk
[SwitchA-Ethernet1/0/12] port t
[SwitchA-Ethernet1/0/12] port trunk permit vlan 200 600
[SwitchA-Ethernet1/0/12] quit
# Configure Ethernet 1/0/10 of Sw
500, and VLAN 600.
[SwitchA] interface Ethernet 1/0/10
[SwitchA-Etherne t1/0/10] port link-type trunk
[SwitchA-Ethernet1/0/10] po
[SwitchA-Ethernet1/0/10] quit
# Configure Layer-2 ACLs on Switch A. Config
4001 to permit packets from VLAN 200, ACL 4002 to permit pack
permit packets from VLAN 600.
[SwitchA] acl number 4000
[SwitchA-acl-ethernetframe-4000] rule permit source 100
[SwitchA] quit
[SwitchA] acl number 4001
[SwitchA-acl-ethernetframe-4001] rule permit source 200
[SwitchA] quit
[SwitchA] acl number 4002
[SwitchA-acl-ethernetframe-4002
[SwitchA] quit
[SwitchA] acl number 4003
[SwitchA-acl-ethernetframe-4003] rule permit source 600
[SwitchA] quit
d VLAN 200 and service VLANs VLAN 500 and VLAN 600 on
0/11
runk pvid vlan 200
itch A as a trunk port, and assign it to VLAN 100, VLAN 200, VLAN
rt trunk permit vlan 100 200 500 600
ure ACL 4000 to permit packets from VLAN 100, ACL
] rule permit source 500
45-27
d configure its default VLAN as VLAN 100.
et 1/0/12 in the same way.
ets from VLAN 500, and ACL 4003 to