Configuring Automatic Bandwidth Adjustment; Configuration Prerequisites; Configuration Procedure - 3Com MSR 50 Series Configuration Manual

Configuring
Automatic Bandwidth
Adjustment
Configuration
Prerequisites

Configuration Procedure

To do...
Enter interface view of MPLS
TE link
Assign a TE metric to the link
n
The metric type configured in MPLS TE tunnel interface view takes priority over
■
the one configured in MPLS view.
If you do not configure the mpls te path metric-type command in MPLS TE
■
tunnel interface view, the configuration in MPLS view takes effect.
Configuring the traffic flow type of a tunnel
Follow these steps to configure the traffic flow type of a tunnel:
To do...
Enter system view
Enter MPLS TE tunnel
interface view
Configure the traffic flow type
of the TE tunnel
Submit current tunnel
configuration
n
Support for this feature varies by device.
The configurations described in this section are used in conjunction with CSPF and
the dynamic signaling protocol CR-LDP or RSVP-TE.
Follow these steps to configure automatic bandwidth adjustment:
To do...
Enter system view
Enter MPLS view
Enable automatic bandwidth
adjustment, and configure
output rate sampling for
automatically bandwidth
tuned TE tunnels
Enter MPLS TE tunnel
interface view

Configuring Automatic Bandwidth Adjustment

Use command to...
interface interface-type
interface-number
mpls te metric value
Use command to...
system-view
interface tunnel
tunnel-number
mpls te vpn-binding { acl
acl-number | vpn-instance
vpn-instance-name }
mpls te commit
Use command to...
system-view
mpls
mpls te timer
auto-bandwidth [ seconds ]
interface tunnel
tunnel-number
1379
Remarks
--
Optional
If no TE metric is assigned to
the link, IGP metric is used as
the TE metric by default.
Remarks
--
--
Optional
Traffic flow types of TE
tunnels are not restricted by
default.
Required
Remarks
--
--
Required
Automatic bandwidth
adjustment is disabled by
default.
--