Configuration Prerequisites; Enabling Msdp - 3Com MSR 50 Series Configuration Manual

1138 C 70: MSDP C
HAPTER
Configuring Basic
Functions of MSDP
Configuration
Prerequisites

Enabling MSDP

ONFIGURATION
Task
"Configuring an MSDP Peer
Connection" on page 1140
"Configuring SA Messages" on
page 1141
n
All the configuration tasks shall be implemented on RPs in PIM-SM domains, and
each of these RPs acts as an MSDP peer.
Before configuring the basic functions of MSDP, complete the following tasks:
Configure any unicast routing protocol so that all devices in the domain are
■
interoperable at the network layer.
Configuring PIM-SM to enable intra-domain multicast forwarding.
■
Before configuring the basic functions of MSDP, prepare the following data:
IP addresses of MSDP peers
■
Address prefix list for an RP address filtering policy
■
Enabling MSDP globally in the public instance
Follow these steps to enable MSDP globally in the public instance:
To do...
Enter system view
Enable IP multicast routing
Enable MSDP and enter public
instance MSDP view
Enabling MSDP in a VPN instance
To do...
Enter system view
"Configuring MSDP Peer
Description" on page 1140
"Configuring an MSDP
Mesh Group" on page 1140
"Configuring MSDP Peer
Connection Control" on
page 1141
"Configuring SA Message
Content" on page 1142
"Configuring SA Request
Messages" on page 1142
"Configuring an SA
Message Filtering Rule" on
page 1143
"Configuring SA Message
Cache" on page 1144
Use the command...
system-view
multicast routing-enable
msdp [ vpn-instance
vpn-instance-name ]
Use the command...
system-view
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
-
Required
Disabled by default
Required
Disabled by default
Description
-