Tcp Test Configuration Example - 3Com MSR 50 Series Configuration Manual

2036 C 109: NQA O
HAPTER
TCP Test Configuration
Example
VERVIEW
Network requirements
Use the NQA TCP function to test the time for establishing a TCP connection
between the local port (Device A) and the specified destination port (Device B).
The port number used is 9000.
Network diagram
Figure 604 Network diagram for the TCP test
NQA client
10 .1.1.1/16
Device A
Configuration procedure
1 Configure Device B.
# Enable the NQA server and configure the listening IP address as 10.2.2.2 and
port number as 9000.
<DeviceB> system-view
[DeviceB] nqa server enable
[DeviceB] nqa server tcp-connect 10.2.2.2 9000
2 Configure Device A.
# Create a TCP test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type tcp
[DeviceA-nqa-admin-test-tcp] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-tcp] destination port 9000
[DeviceA-nqa-admin-test-tcp] quit
# Enable the TCP test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of one TCP test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 13/13/13
Square-Sum of round trip time: 169
Last succeeded probe time: 2000-04-27 14:03:20.1
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
NQA server
10 .2 .2.2/16
IP network
Device B