3Com MSR 50 Series Configuration Manual page 1420

1420 C 77: MPLS TE C
HAPTER ONFIGURATION
4 Configure an MPLS TE tunnel
# Create a TE tunnel with PE 1 as the headend and PE 2 as the tail. The signaling
protocol is CR-LDP.
[PE1] interface tunnel 1
[PE1-Tunnel1] ip address 12.1.1.1 255.255.255.0
[PE1-Tunnel1] tunnel-protocol mpls te
[PE1-Tunnel1] destination 3.3.3.3
[PE1-Tunnel1] mpls te tunnel-id 10
[PE1-Tunnel1] mpls te signal-protocol crldp
[PE1-Tunnel1] mpls te commit
[PE1-Tunnel1] quit
Perform the display interface tunnel command on PE 1. You can see that the
tunnel interface is up.
5 Configure the VPN instance on each PE, and bind it to the interface connected to
the CE
# Configure on CE 1.
[CE1] interface ethernet 1/0
[CE1-Ethernet1/0] ip address 192.168.1.2 255.255.255.0
[CE1-Ethernet1/0] quit
# Configure the VPN instance on PE 1, and use CR-LSP for VPN setup. Bind the
VPN instance with the interface connected to CE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 100:1 both
[PE1-vpn-instance-vpn1] tnl-policy policy1
[PE1-vpn-instance-vpn1] quit
[PE1] tunnel-policy policy1
[PE1-tunnel-policy-policy1] tunnel select-seq cr-lsp load-balance-number 1
[PE1-tunnel-policy-policy1] quit
[PE1] interface ethernet 1/0
[PE1-Ethernet1/0] ip binding vpn-instance vpn1
[PE1-Ethernet1/0] ip address 192.168.1.1 255.255.255.0
[PE1-Ethernet1/0] quit
# Configure on CE 2.
[CE2] interface ethernet 1/0
[CE2-Ethernet1/0] ip address 192.168.2.2 255.255.255.0
[CE2-Ethernet1/0] quit
# Configure the VPN instance on PE 2, and bind it with the interface connected to
CE 2.
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 100:2
[PE2-vpn-instance-vpn1] vpn-target 100:1 both
[PE2-vpn-instance-vpn1] quit
[PE2] interface ethernet 1/0
[PE2-Ethernet1/0] ip binding vpn-instance vpn1