3Com MSR 50 Series Configuration Manual page 1387

[RouterB] interface ethernet 1/0
[RouterB-Ethernet1/0] isis enable 1
[RouterB-Ethernet1/0] quit
[RouterB] interface ethernet1/1
[RouterB-Ethernet1/1] isis enable 1
[RouterB-Ethernet1/1] quit
[RouterB] interface loopback 0
[RouterB-LoopBack0] isis enable 1
[RouterB-LoopBack0] quit
# Configure Router C.
<RouterB> system-view
[RouterC] isis 1
[RouterC-isis-1] network-entity 00.0005.0000.0000.0003.00
[RouterC-isis-1] quit
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] isis enable 1
[RouterC-Ethernet1/1] quit
[RouterC] interface loopback 0
[RouterC-LoopBack0] isis enable 1
[RouterC-LoopBack0] quit
Perform the display ip routing-table command on each router. You can see that
all nodes learnt the host routes of other nodes with LSR IDs as destinations. Take
Router A for example:
[RouterA] display ip routing-table
Routing Tables: Public
Destinations : 8
Destination/Mask
1.1.1.1/32
2.1.1.0/24
2.1.1.1/32
2.2.2.2/32
3.2.1.0/24
3.3.3.3/32
127.0.0.0/8
127.0.0.1/32
3 Configure MPLS TE basic capabilities
# Configure Router A.
[RouterA] mpls lsr-id 1.1.1.1
[RouterA] mpls
[RouterA-mpls] mpls te
[RouterA-mpls] quit
[RouterA] interface ethernet 1/0
[RouterA-Ethernet1/0] mpls
[RouterA-Ethernet1/0] mpls te
[RouterA-Ethernet1/0] quit
# Configure Router B.
[RouterB] mpls lsr-id 2.2.2.2
[RouterB] mpls
[RouterB-mpls] mpls te
MPLS TE Configuration Example
Routes : 8
Proto Pre Cost
Direct 0 0
Direct 0 0
Direct 0 0
ISIS 15 10
ISIS 15 20
ISIS 15 20
Direct 0 0
Direct 0 0
NextHop Interface
127.0.0.1 InLoop0
2.1.1.1 Eth1/0
127.0.0.1 InLoop0
2.1.1.2 Eth1/0
2.1.1.2 Eth1/0
2.1.1.2 Eth1/0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
1387