Mpls Te Configuration Example; Mpls Te Using Static Cr-Lsp Configuration Example - 3Com MSR 50 Series Configuration Manual

1386 C 77: MPLS TE C
HAPTER
MPLS TE
Configuration
Example
MPLS TE Using Static
CR-LSP Configuration
Example
ONFIGURATION
Network requirements
Router A, Router B, and Router C run IS-IS.
■
Establish a TE tunnel using a static CR-LSP between Router A and Router C.
■
Network diagram
Figure 390 Set up MPLS TE tunnels using static CR-LSPs
Loop 0
2.2.2.2/32
Eth1/0
2.1.1.2 /24
Router B
Eth1/0
2.1.1.1 /24
Router A
Loop 0
1.1.1.1/32
Configuration procedure
1 Assign IP addresses and masks to interfaces (see
Omitted
2 Enable IS-IS to advertise host routes with LSR IDs as destinations
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] network-entity 00.0005.0000.0000.0001.00
[RouterA-isis-1] quit
[RouterA] interface ethernet 1/0
[RouterA-Ethernet1/0] isis enable 1
[RouterA-Ethernet1/0] quit
[RouterA] interface loopback 0
[RouterA-LoopBack0] isis enable 1
[RouterA-LoopBack0] quit
# Configure Router B.
<RouterB> system-view
[RouterB] isis 1
[RouterB-isis-1] network-entity 00.0005.0000.0000.0002.00
[RouterB-isis-1] quit
Eth1/0
3.2.1 .1/24
Eth1 /0
3.2.1 .2/24
Router C
Loop 0
3.3 .3.3/32
Figure 390)