Configuring Mpls Te Basic Capabilities; Configuration Prerequisites; Configuration Procedure - 3Com MSR 50 Series Configuration Manual

Configuring MPLS TE
Basic Capabilities
Configuration
Prerequisites

Configuration procedure

Configuration task
"Configuring Automatic Bandwidth Adjustment" on page 1379
"Configuring CR-LSP Backup" on page 1380
"Configuring FRR" on page 1381
MPLS TE basic capabilities are essential to MPLS TE feature configurations. After
configuring the basic capabilities, you need to make other configurations in order
to use MPLS TE depending on the actual requirements.
Before the configuration, do the following:
Configure static routing or IGPs to make sure all LSRs are reachable.
■
Configure MPLS basic capabilities.
■
n
For configuration information about MPLS basic capability, refer to
MPLS Basic Capability" on page
Follow these steps to configure MPLS TE basic capabilities:
To do...
Enter system view
Enter MPLS view
Enable global MPLS TE
Exit to system view
Enter the interface view of an MPLS
TE link
Enable interface MPLS TE
Exit to system view
Create a tunnel interface and enter
its view
Assign an IP address to the tunnel
interface
Set the tunnel protocol to MPLS TE tunnel-protocol mpls te
Configure the destination address
of the tunnel
Configure the tunnel ID of the
tunnel
Submit the current tunnel
configuration
n
Depending on the MPLS TE signaling protocol a tunnel uses, the basic
■
capabilities you configured in this section may be inadequate for the tunnel to
work and you may need to make extra configurations.
For information about tunnel interfaces, refer to
■
page 693.

Configuring MPLS TE Basic Capabilities

1325.
Use the command...
system-view
mpls
mpls te
quit
interface interface-type
interface-number
mpls te
quit
interface tunnel
tunnel-number
ip address ip-address
netmask
destination ip-address
mpls te tunnel-id tunnel-id Required
mpls te commit
"Tunneling Configuration" on
1359
Remarks
Optional
Optional
Optional
"Configuring
Remarks
--
--
Required
Disabled by default
--
--
Required
Disabled by default
--
Required
Required
Required
Required
Required