Example For Configuring A Kompella Local Connection - 3Com MSR 50 Series Configuration Manual

Example for Configuring
a Kompella Local
Connection
1 total connections,
connections: 1 up, 0 down, 0 local, 1 remote, 0 unknown
CE name: ce1, id: 1,
Rid type status peer-id
2 rmt up
[CE1] ping 30.1.1.2
PING 30.1.1.2: 56
Reply from 30.1.1.2: bytes=56 Sequence=1 ttl=255 time=90 ms
Reply from 30.1.1.2: bytes=56 Sequence=2 ttl=255 time=77 ms
Reply from 30.1.1.2: bytes=56 Sequence=3 ttl=255 time=34 ms
Reply from 30.1.1.2: bytes=56 Sequence=4 ttl=255 time=46 ms
Reply from 30.1.1.2: bytes=56 Sequence=5 ttl=255 time=94 ms
--- 30.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 34/68/94 ms
Network requirements
A Kompella local connection is required between CE 1 and CE 2.
Network diagram
Figure 404 Network diagram for configuring a Kompella local connection
Kompella local connection
S2/0
30.1.1.1 /24
CE 1
Configuration procedure
1 Configure the PE
# Configure MPLS basic capability.
The configuration steps are omitted.
# Configure the L2VPN and the CE connection.
<Sysname> system-view
[Sysname] sysname PE
[PE] mpls l2vpn
[PE] mpls l2vpn vpn1 encapsulation ppp
[PE-mpls-l2vpn-vpn1] route-distinguisher 100:1
[PE-mpls-l2vpn-vpn1] vpn-target 111:1
[PE-mpls-l2vpn-vpn1] ce ce1 id 1
[PE-mpls-l2vpn-ce-vpn1-ce1] connection ce-offset 2 interface serial 2/0
[PE-mpls-l2vpn-ce-vpn1-ce1] quit
[PE-mpls-l2vpn-vpn1] ce ce2 id 2
MPLS L2VPN Configuration Example
route-distinguisher
3.3.3.9 100:1
data bytes, press CTRL_C to break
CE 2
S2/0
30.1.1.2 /24
S2/1
S2/0
PE
1455
intf
Serial2/0