3Com MSR 50 Series Configuration Manual page 1395

[RouterA-Tunnel1] mpls te signal-protocol rsvp-te
[RouterA-Tunnel1] mpls te bandwidth 2000
[RouterA-Tunnel1] mpls te commit
[RouterA-Tunnel1] quit
7 Verify the configuration
Perform the display interface tunnel command on Router A. You can find that
the tunnel interface is up.
[RouterA] display interface tunnel
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 64000
Internet Address is 7.1.1.1/24 Primary
Encapsulation is TUNNEL, aggregation ID not set
Tunnel source unknown, destination 4.4.4.9
Tunnel protocol/transport CR_LSP
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
Perform the display mpls te tunnel-interface command on Router A to verify
information about the MPLS TE tunnel.
[RouterA] display mpls te tunnel-interface
Tunnel Name
Tunnel Desc
Tunnel State Desc :
Tunnel Attributes :
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
Class Type
Reserved BW
Setup Priority
Affinity Prop/Mask
Explicit Path Name
Tie-Breaking Policy :
Metric Type
Record Route
FRR Flag
BackUpBW Type
Route Pinning
Retry Limit
Reopt
Back Up Type
Back Up LSPID
Auto BW
Min BW
Current Collected BW:
Interfaces Protected:
VPN Bind Type
VPN Bind Value
Car Policy
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
: Tunnel1
: Tunnel1 Interface
CR-LSP is Up
: 1.1.1.9:3
: 10
: UP
: 1.1.1.9
: RSVP
: CLASS 0
: 2000 kbps
: 7
: 0x0/0x0
: -
None
: None
: Disabled Record Label :
: Disabled BackUpBW Flag:
: - BackUpBW
: Disabled
: 5 Retry Interval:
: Disabled Reopt Freq
: None
: -
: Disabled Auto BW Freq :
: - Max BW
-
-
: NONE
: -
: Disabled
MPLS TE Configuration Example
Oper State : UP
Egress LSR ID: 4.4.4.9
Resv Style : SE
Tunnel BW : 2000 kbps
Hold Priority: 7
Disabled
Not Supported
: -
10 sec
: -
-
: -
1395