Mpls Te Using Cr-Ldp Configuration Example - 3Com MSR 50 Series Configuration Manual

1398 C 77: MPLS TE C
HAPTER
MPLS TE Using CR-LDP
Configuration Example
ONFIGURATION
<RouterB> system-view
[RouterB] mpls
[RouterB-mpls] mpls rsvp-te graceful-restart
# Configure Router B.
<RouterC> system-view
[RouterC] mpls
[RouterC-mpls] mpls rsvp-te graceful-restart
# Configure Router C.
<RouterC> system-view
[RouterC] mpls
[RouterC-mpls] mpls rsvp-te graceful-restart
7 Verify the configuration
# After the above configuration, a tunnel will be created between Router A and
Router C. Issuing the following command, you should see that the neighbor's GR
status is Ready.
<RouterA> display mpls rsvp-te peer
Interface Ethernet1/0
Neighbor Addr: 10.1.1.2
SrcInstance: 880
PSB Count: 0
Hello Type Sent: REQ
SRefresh Enable: NO
Graceful Restart State: Ready
Restart Time: 120 Sec
Network requirements
Router A, Router B, Router C and Router D are running OSPF and all of them are in
area 0.
Use CR-LDP to create a TE tunnel with 2000 kbps of bandwidth from Router A to
Router D, ensuring that the maximum bandwidth of each link that the tunnel
traverses is 10000 kbps and the maximum reservable bandwidth is 5000 kbps.
NbrSrcInstance: 5017
RSB Count: 1
Neighbor Hello Extension: ENABLE
Recovery Time: 300 Sec