Snmp Test Configuration Example - 3Com MSR 50 Series Configuration Manual

3com msr 30-16: software guide
Hide thumbs Also See for MSR 50 Series:
Table of Contents

Advertisement

SNMP Test
Configuration Example
Network requirements
Use the NQA SNMP query function to test the time it takes Device A to send an
SNMP query packet to the SNMP agent and receive a response packet.
Network diagram
Figure 603 Network diagram for SNMP test
NQA client
10 .1.1.1/16
IP network
Device A
Configuration procedure
1 Configurations on SNMP agent.
# Enable the SNMP agent service and set the SNMP version to all, the read
community to public, and the write community to private.
<DeviceB> system-view
[DeviceB] snmp-agent sys-info version all
[DeviceB] snmp-agent community read public
[DeviceB] snmp-agent community write private
2 Configurations on Device A.
# Create an SNMP query test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type snmp
[DeviceA-nqa-admin-test-snmp] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-snmp] quit
# Enable the SNMP query test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of an SNMP test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1
Min/Max/Average round trip time: 50/50/50
Square-Sum of round trip time: 2500
Last succeeded probe time: 2007-03-27 13:59:43.1
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
NQA Configuration Examples
SNMP agent
10 .2 .2.2/16
Device B
Receive response times: 1
2035

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents