n
Configuring Local LDP
Session Parameters
Configuring Remote LDP
Session Parameters
To do...
Enter interface view
Enable LDP capability on the
interface
Currently, these types of interfaces support LDP capability: serial interface,
■
async interface, Layer 3 Ethernet interface (Ethernet interface, GE interface,
and XGE interface), ATM interface, POS interface, Layer 3 virtual Ethernet
interface (that is, virtual-Ethernet interface), virtual template, Mp-group
interface, MFR interface, tunnel interface, VLAN interface, and virtual dial
template (that is, dialer).
Disabling LDP on an interface terminates all LDP sessions on the interface,
■
causing all LSPs using the sessions to be deleted.
Usually, the default value of the LDP LSR ID, that of the MPLS LSR ID, answers
■
the requirement. In some networking schemes where VPN instances are
deployed, such as MPLS L3VPN networking schemes, if the address space of a
VPN and that of the public network overlap, you must configure an LDP LSR ID
that is different from the MPLS LSR ID for the TCP connection to be established
normally.
You can configure the local session transport address to be the IP address of the
interface, or that of a specified interface.
Follow these steps to configure local LDP session parameters:
To do...
Enter system view
Enter interface view
Set the link Hello timer
Set the link Keepalive timer mpls ldp timer
Configure the LDP transport
address
Configure the remote session transport address to be the IP address of a specified
interface.
Follow these steps to configure remote LDP session parameters:
To do...
Enter system view
Create a remote peer entity
and enter MPLS LDP remote
peer view
Use the command...
interface interface-type
interface-number
mpls ldp
Use the command...
system-view
interface interface-type
interface-number
mpls ldp timer hello-hold
value
keepalive-hold value
mpls ldp transport-address
{ interface-type
interface-number | interface }
Use the command...
system-view
mpls ldp remote-peer
remote-peer-name
Configuring MPLS LDP
1329
Remarks
-
Required
Not enabled by default
Remarks
-
-
Optional
15 seconds by default
Optional
45 seconds by default
Optional
MPLS LSR ID of the LSR by
default
Remarks
-
Required
Need help?
Do you have a question about the MSR 50 Series and is the answer not in the manual?