Configuring Kompella Mpls L2Vpn; Configuration Procedure; Configuration Prerequisites - 3Com MSR 50 Series Configuration Manual

Configuration Procedure

Configuring Kompella
MPLS L2VPN
Configuration
Prerequisites
Configuration Procedure
Tunneling policy
■
Follow these steps to configure Martini MPLS L2VPN on the PE:
To do...
Enter system view
Enter interface view for
the interface connecting
the CE
Create a Martini MPLS
L2VPN connection
Return to system view
Configure the remote peer mpls ldp remote-peer
n
For remote peer configuration information, refer to
on page 1311.
c
CAUTION: For a Martini connection, there are two main parameters: one is the IP
address of the peer PE, the other is the VC ID. The combination of the VC ID and
the encapsulation type must be unique on a PE. Changing the encapsulation type
may result in VC ID conflicts.
Kompella MPLS L2VPN uses extended BGP as the signaling protocol to transfer
L2VPN information between PEs.
To create a Kompella local connection, you only need to configure the VPN and CE
connection on the PE. Neither IGP nor BGP L2VPN capability is required.
Before configuring Kompella MPLS L2VPN, complete these tasks:
Configuring IGP on the PEs and P devices to guarantee the IP connectivity of
■
the MPLS backbone
Configuring MPLS basic capability and MPLS LDP for the MPLS backbone on
■
the PEs and P devices to establish LDP LSPs
Enabling MPLS L2VPN on the PEs
■
To configure Kompella MPLS L2VPN, you need the following data:
AS numbers of the local PE and the peer PE
■
Name, RD, and VPN Target attributes of the L2VPN connection
■
CE name, CE ID, and CE range
■
CE offset
■
Configuring BGP L2VPN capability
Follow these steps to configure BGP L2VPN capability:

Configuring Kompella MPLS L2VPN

Use the command...
system-view
interface interface-type
interface-number
mpls l2vc destination vcid
[ tunnel-policy tunnel-policy-name ]
[ control-word | no-control-word ]
quit
remote-peer-name
remote-ip ip-address
Remarks
-
-
Required
-
Required
Required
"MPLS Basics Configuration"
1435