Configuring MPLS TE Tunnel with Dynamic Signaling Protocol
To do...
Add a node to the explicit
path
Specify a next hop IP address
on the explicit path
Modify the IP address of
current node on the explicit
path
Remove a node from the
explicit path
Display information about the
specified or all nodes on the
explicit path
Configuring MPLS TE tunnel constraints
Follow these steps to configure MPLS TE tunnel constraints:
To do...
Enter system view
Enter MPLS TE tunnel
interface view
Assign bandwidth to the
MPLS TE tunnel
Associate the tunnel with an
explicit path
Submit current tunnel
configuration
Establishing an MPLS TE tunnel with CR-LDP
Follow these steps to establish an MPLS TE tunnel with CR-LDP:
To do...
Enter system view
Enter MPLS TE tunnel
interface view
Use command to...
add hop ip-address1
[ include [ loose | strict ] |
exclude ] { after | before }
ip-address2
next hop ip-address
[ include [ loose | strict ] |
exclude ]
modify hop ip-address1
ip-address2 [ [ include
[ loose | strict ] | exclude ]
delete hop ip-address
list hop [ ip-address ]
Use command to...
system-view
interface tunnel
tunnel-number
mpls te bandwidth [ bc0 |
bc1 ] bandwidth
mpls te path explicit-path
path-name
mpls te commit
Use command to...
system-view
interface tunnel
tunnel-number
1365
Remarks
Optional
By default, the include
keyword and the strict
keyword apply. In other
words, the explicit path
traverses the specified node
and the next node is a strict
node.
Required
The next hop is a strict node
by default.
Repeat this step to define a
sequential set of the hops that
the explicit path traverses.
Optional
By default, the include
keyword and the strict
keyword apply. In other
words, the explicit path
traverses the specified node
and the next node is a strict
node.
Optional
Optional
Remarks
--
--
Optional
No bandwidth is assigned by
default.
Required
Required
Remarks
--
--
Need help?
Do you have a question about the MSR 50 Series and is the answer not in the manual?