3Com MSR 50 Series Configuration Manual page 2002

2002 C 107: VRRP C
HAPTER ONFIGURATION
[RouterA-Ethernet1/0] vrrp ipv6 vrid 1 priority 110
# Create standby group 2 set its virtual IP address to FE80::20.
[RouterA-Ethernet1/0] vrrp ipv6 vrid 2 virtual-ip fe80::20 link-local
2 Configure Router B
<RouterB> system-view
[RouterB] ipv6
[RouterB] interface ethernet 1/0
[RouterB-Ethernet1/0] ipv6 address fe80::2 link-local
[RouterB-Ethernet1/0] ipv6 address 1::2 64
# Create standby group 1 and set its virtual IP address to FE80::10.
[RouterB-Ethernet1/0] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
# Create standby group 2 set its virtual IP address to FE80::20.
[RouterB-Ethernet1/0] vrrp ipv6 vrid 2 virtual-ip fe80::20 link-local
# Set the priority of Router B in standby group 2 to 110.
[RouterB-Ethernet1/0] vrrp ipv6 vrid 2 priority 110
3 Verify the configuration
You can use the display vrrp ipv6 command to verify the configuration.
# Display detailed information of the standby group on Router A.
[RouterA-Ethernet1/0] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
# Display detailed information of the standby group on Router B.
[RouterB-Ethernet1/0] display vrrp ipv6 verbose
IPv6 Standby Information:
: VIRTUAL-MAC
: Ethernet1/0
: 1
: UP
: 110
: YES
: NONE
: FE80::10
: 0000-5e00-0201
: FE80::1
: Ethernet1/0
: 2
: UP
: 100
: YES
: NONE
: FE80::20
: FE80::2
Adver. Timer : 100
State : Master
Run Pri : 110
Delay Time : 0
Adver. Timer : 100
State : Backup
Run Pri : 100
Delay Time : 0