Configuring Options Related To Dial Plan; Configuring Adjustment Functions; Configuration Task List - 3Com MSR 50 Series Configuration Manual

Configuring Options
Related to Dial Plan
Configuring
Adjustment Functions

Configuration Task List

Sensitivity detection: If the DTMF detection sensitivity is high, the reliability is
■
low but a detection error may occur. If the detection sensitivity is low, the
reliability is high but a DTMF may fail to be detected.
Configuration procedure
Follow these steps to configure DTMF detection:
To do...
Enter system view
Enter voice view
Enter voice subscriber line
view
Configure the DTMF
detection sensitivity
Configure the DTMF
detection sensitivity level
Follow these steps to configure options related to dial plan:
To do...
Enter system view
Enter voice view
Enter voice subscriber line
view
Enable the private line auto
ring function
Bind a calling/called number
substitution rule list to a voice
subscriber line
For the operation of the above commands, refer to
page 2289.
The adjustment function configuration involves the following tasks:

Configuring Options Related to Dial Plan

Use the
command... Remarks
system-view -
voice-setup -
subscriber-line -
line-number
dtmf threshold Optional
analog index value
By default, indexes 0 to 12 correspond to
1400, 458, -9, -9, -9, -9, -3, -12, -12, 30,
300, 3200, and 375, respectively. For
meanings of these parameters, refer to VoIP
Commands.
This command is used by professional
personnel to adjust the device in the case of
DTMF detection failure. Usually, the default
value is adopted.
dtmf Optional
sensitivity-level
By default, the DTMF detection sensitivity is
{ high | low }
high.
This command is valid only for the FXS/FXO
voice subscriber line.
Use the command...
system-view
voice-setup
subscriber-line line-number
private-line string
substitute { called | calling }
list-number
Remarks
-
-
-
Optional
Disabled by default.
By default, no number
substitution rule list is bound
to a voice subscriber line.
"Dial Plan Configuration" on
2261