Acsei Timers; Acsei Startup And Running; Acsei Server Configuration; Enabling Acsei Server - 3Com MSR 50 Series Configuration Manual

2200 C 126: ACSEI C
HAPTER

ACSEI Timers

ACSEI Startup and
Running
ACSEI Server
Configuration

Enabling ACSEI Server

ONFIGURATION
Control of the ACSEI clients from an ACSEI server. For example, you can close
■
ACSEI client, or restart ACSEI client from the ACSEI server.
An ACSEI server can register multiple ACSEI clients. The maximum number of
ACSEI clients an ACSEI server allows to register varies with devices.
An ACSEI server uses two timers, the clock synchronization timer and the
monitoring timer.
The clock synchronization timer is used to periodically trigger the ACSEI server
■
to send the clock synchronization advertisements to ACSEI clients. You can set
this timer through command lines.
The monitoring timer is used to periodically trigger the ACSEI server to send
■
monitoring requests to ACSEI clients. You can set this timer through command
lines.
An ACSEI client starts two timers, the registration timer and the monitoring timer.
The registration timer is used to periodically trigger the ACSEI client to
■
multicast the registration requests (with the multicast MAC address being
010F-E200-0021). You cannot set this timer.
The monitoring timer is used to periodically trigger the ACSEI client to send
■
monitoring requests to the ACSEI server. You cannot set this timer.
An ACSEI server and an ACSEI client start up and run in the following procedures:
1 Run the ACSEI client application to enable ACSEI client.
2 Start up the device and enable ACSEI server on it.
3 The ACSEI client multicast registration requests.
4 After the ACSEI server receives a valid registration request, it negotiates
parameters with the ACSEI client and establishes connection with the client if the
negotiation succeeds.
5 The ACSEI server and the ACSEI client mutually monitor the connection.
6 If detecting the disconnection of the ACSEI client, the ACFP will remove the
configuration and policies associated with the client.
Follow these steps to enable ACSEI server:
To do...
Enter system view
Enable ACSEI server
Use the command...
system-view
acsei server enable
Remarks
-
Required