Example For Configuring Kompella Mpls L2Vpn - 3Com MSR 50 Series Configuration Manual

1452 C 78: MPLS L2VPN C
HAPTER
Example for Configuring
Kompella MPLS L2VPN
ONFIGURATION
[PE2] interface serial 2/0
[PE2-Serial2/0] mpls l2vc 192.2.2.2 101
[PE2-Serial2/0] quit
5 Configure CE 2
<Sysname> system-view
[Sysname] sysname CE2
[CE2] interface serial 2/0
[CE2-Serial2/0] ip address 100.1.1.2 24
After completing the above configurations, you can display L2VPN connection
information on PE 1 or PE 2. There should be one L2VPN connection established.
CE 1 should be able to ping interface 100.1.1.2 of CE 2 and CE 2 should be able
to ping interface 100.1.1.1 of CE 1:
[PE1] display mpls l2vc
total ldp vc : 1
Transport Client
VC ID Intf
101 Serial2/0
[PE2] display mpls l2vc
total ldp vc : 1
Transport Client
VC ID Intf
101 Serial2/0
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=30 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=60 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=50 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=40 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=70 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 30/50/70 ms
Network requirements
CE 1 and CE 2 are respectively connected to PE 1 and PE 2 through Serial
■
interfaces. The link layer encapsulation protocol is PPP.
A Kompella MPLS L2VPN is established between CE 1 and CE 2.
■
1 up 0 down
VC Local
State VC Label
up 1024
1 up 0 down
VC Local
State VC Label
up 1025
data bytes, press CTRL_C to break
Remote Tunnel
VC Label Policy
1025 default
Remote Tunnel
VC Label Policy
1024 default