Configuring The Tcp Test - 3Com MSR 50 Series Configuration Manual

2024 C 109: NQA O
HAPTER

Configuring the TCP Test

n
VERVIEW
To do...
Configure the source IP
address of a probe request in
a test operation
Configure common optional
parameters
You are not recommended to perform an NQA TCP test on ports from 1 to 1023
(known ports). Otherwise, the NQA test will fail or the corresponding services of
this port will be unavailable.
The TCP test is used to test the TCP connection between the client and the
specified server and the setup time for the connection.
Configuration prerequisites
A TCP test requires cooperation between the NQA server and the NQA client. The
TCP listening function needs to be configured on the NQA server before the TCP
test.
Configuring the TCP test
Follow these steps to configure the TCP test:
To do...
Enter system view
Enter NQA test group view
Configure the test type as TCP
and enter test type view
Configure the destination
address for a test operation
Use the command...
source ip ip-address
Refer to "Configuring
Optional Parameters Common
to an NQA Test Group" on
page 2028
Use the command...
system-view
nqa entry admin-name
operation-tag
type tcp
destination ip ip-address
Remarks
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Optional
Remarks
-
-
Required
Required
By default, no destination IP
address is configured for a
test operation.
The destination address must
be the IP address of the
listening service configured on
the NQA server.