Setting To Save System Information To A Log File - 3Com MSR 50 Series Configuration Manual

Setting to Save System
Information to a Log File
To do...
Configure the output rules
of the system information
Configure the format of
the timestamp
n
To ensure that system information can be output to the SNMP NMS, you need to
make the necessary configurations on the SNMP agent and the NMS. For detailed
information on SNMP, refer to
With the log file feature enabled, the log information generated by system can be
saved to a specified directory with a predefined frequency. This allows you to
check the operation history at any time to ensure that the device functions
properly.
Follow these steps to set to save system information to a log file:
To do...
Enter system view
Enable the log file feature
Configure the frequency with
which the log file is saved
Configure the maximum
storage space reserved for a
log file
Configure the directory to
save the log file
Manually save the log buffer
content to the log file
n
To ensure the device to work normally, use the info-center logfile size-quota
■
command to set a logfile to be no smaller than 1 MB and no larger than 10
MB.
Configuring Information Center
Use the command...
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state }* | log
{ level severity | state state }* |
trap { level severity | state
state }* ]*
info-center timestamp
{ debugging | log | trap | }
{ boot | date | none }
"SNMP Configuration" on page
Use the command...
system-view
info-center logfile enable
info-center logfile
frequency freq-sec
info-center logfile
size-quota size
info-center logfile
switch-directory dir-name
logfile save
2147
Remarks
Optional
Refer to Table 71 for the
output rules of the system
information.
Optional
The time stamp for log, trap
and debug information is
date by default.
2085.
Remarks
-
Optional
Enabled by default
Optional
The default value varies with
devices.
Optional
The default value varies with
devices.
Optional
By default, the logfile
directory under the root
directory of the memory
device, which varies with
devices.
Optional
Available in any view
By default, the system saves
the log file with the frequency
defined by the info-center
logfile frequency command.