3Com MSR 50 Series Configuration Manual page 1421

[PE2-Ethernet1/0] ip address 192.168.2.1 255.255.255.0
[PE2-Ethernet1/0] quit
Perform the display ip vpn-instance command on the PEs to verify the
configuration of the VPN instance. Take PE 1 for example:
[PE1] display ip vpn-instance instance-name vpn1
VPN-Instance Name and ID : vpn1, 1
Create time : 2006/09/27 15:10:29
Up time : 0 days, 00 hours, 03 minutes and 09 seconds
Route Distinguisher : 100:1
Export VPN Targets :
Import VPN Targets :
Tunnel Policy : policy1
Interfaces : Ethernet1/0
Ping connected CEs on PEs to test connectivity. For example, ping CE 1 on PE 1:
[PE1] ping -vpn-instance vpn1 192.168.1.2
PING 192.168.1.2: 56
Reply from 192.168.1.2: bytes=56 Sequence=1 ttl=255 time=47 ms
Reply from 192.168.1.2: bytes=56 Sequence=2 ttl=255 time=26 ms
Reply from 192.168.1.2: bytes=56 Sequence=3 ttl=255 time=26 ms
Reply from 192.168.1.2: bytes=56 Sequence=4 ttl=255 time=26 ms
Reply from 192.168.1.2: bytes=56 Sequence=5 ttl=255 time=26 ms
--- 192.168.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 26/30/47 ms
The sample output shows that PE 1 can reach CE 1.
6 Configure BGP
# Configure CE 1.
[CE1] bgp 65001
[CE1-bgp] peer 192.168.1.1 as-number 100
[CE1-bgp] quit
# Configure PE 1 to establish the EBGP peer relationship with CE 1, and the IBGP
peer relationship with PE 2.
[PE1] bgp 100
[PE1-bgp] ipv4-family vpn-instance vpn1
[PE1-bgp-vpn1] peer 192.168.1.2 as-number 65001
[PE1-bgp-vpn1] import-route direct
[PE1-bgp-vpn1] quit
[PE1-bgp] peer 3.3.3.3 as-number 100
[PE1-bgp] peer 3.3.3.3 connect-interface loopback 0
[PE1-bgp] ipv4-family vpnv4
[PE1-bgp-af-vpnv4] peer 3.3.3.3 enable
[PE1-bgp-af-vpnv4] quit
[PE1-bgp] quit
# Configure CE 2.
MPLS TE Configuration Example
100:1
100:1
data bytes, press CTRL_C to break
1421