3Com MSR 50 Series Configuration Manual page 1586

1586 C 80: DVPN C
HAPTER ONFIGURATION
# Create a local user named dvpn1spoke1, setting the password as dvpn1spoke1.
[Spoke1-Vam-client-name-dvpn1spoke1] user dvpn1spoke1 password simple dvpn1spoke1
[Spoke1-Vam-client-name-dvpn1spoke1] client enable
[Spoke1-Vam-client-name-dvpn1spoke1] quit
Configure the IPSec profile
■
# Configure the IPSec proposal.
[Spoke1] ipsec proposal vam
[Spoke1-ipsec-proposal-vam] encapsulation-mode tunnel
[Spoke1-ipsec-proposal-vam] transform esp
[Spoke1-ipsec-proposal-vam] esp encryption-algorithm des
[Spoke1-ipsec-proposal-vam] esp authentication-algorithm sha1
[Spoke1-ipsec-proposal-vam] quit
# Configure the IKE peer.
[Spoke1] ike peer vam
[Spoke1-ike-peer-vam] pre-shared-key abcde
[Spoke1-ike-peer-vam] quit
# Configure the IPSec profile.
[Spoke1] ipsec profile vamp
[Spoke1-ipsec-profile-vamp] proposal vam
[Spoke1-ipsec-profile-vamp] ike-peer vam
[Spoke1-ipsec-profile-vamp] sa duration time-based 600
[Spoke1-ipsec-profile-vamp] pfs dh-group2
Configure the DVPN tunnel
■
# Configure tunnel interface Tunnel 1 for VPN 1.
[Spoke1] interface tunnel 1
[Spoke1-Tunnel1] tunnel-protocol dvpn udp
[Spoke1-Tunnel1] vam client dvpn1spoke1
[Spoke1-Tunnel1] ip address 10.0.1.3 255.255.255.0
[Spoke1-Tunnel1] source ethernet 1/0
[Spoke1-Tunnel1] ospf network-type p2mp
[Spoke1-Tunnel1] ipsec profile vamp
[Spoke1-Tunnel1] quit
Configure OSPF
■
# Configure OSPF for the public network.
[Spoke1] ospf 100
[Spoke1-ospf-100] area 0
[Spoke1-ospf-100-area-0.0.0.0] network 192.168.1.3 0.0.0.255
[Spoke1-ospf-100-area-0.0.0.0] quit
# Configure OSPF for the private network.
[Spoke1] ospf 200
[Spoke1-ospf-200] area 0
[Spoke1-ospf-200-area-0.0.0.0] network 10.0.1.3 0.0.0.255
[Spoke1-ospf-200-area-0.0.0.0] quit
6 Configure Spoke 2
Configure the IP addresses of the interfaces (Omitted)
■
Configure the VAM client
■
<Spoke2> system-view
# Create a client named dvpn1spoke2 for VPN 1.