Specifying The Radius Authentication/Authorization Servers; Configuring The Radius Accounting Servers And Relevant Parameters - 3Com MSR 50 Series Configuration Manual

1770 C 93: AAA/RADIUS/HWTACACS C
HAPTER
c
Specifying the RADIUS
Authentication/Authoriz
ation Servers
n
Configuring the RADIUS
Accounting Servers and
Relevant Parameters
ONFIGURATION
To do...
Create a RADIUS scheme and enter
RADIUS scheme view
CAUTION: A RADIUS scheme can be referenced by more than one ISP domain at
the same time.
Follow these steps to specify the RADIUS authentication/authorization servers:
To do...
Enter system view
Create a RADIUS scheme and
enter RADIUS scheme view
Configure the IP address and
UDP port of the primary
RADIUS
authentication/authorization
server
Configure the IP address and
UDP port of the secondary
RADIUS
authentication/authorization
server
In practice, you may specify two RADIUS servers as the primary and secondary
■
authentication/authorization servers respectively. At a moment, a server can be
the primary authentication/authorization server for a scheme and the
secondary authentication/authorization servers for another scheme.
The IP addresses of the primary and secondary authentication/authorization
■
servers for a scheme cannot be the same. Otherwise, the configuration fails.
Follow these steps to specify the RADIUS accounting servers and perform related
configurations:
To do...
Enter system view
Create a RADIUS scheme and
enter RADIUS scheme view
Configure the IP address and
UDP port of the primary
RADIUS accounting server
Use the command...
radius scheme
radius-scheme-name
Use the command...
system-view
radius scheme
radius-scheme-name
primary authentication
ip-address [ port-number ]
secondary authentication
ip-address [ port-number ]
Use the command...
system-view
radius scheme
radius-scheme-name
primary accounting
ip-address [ port-number ]
Remarks
Optional
By default, no RADIUS
scheme is created.
Remarks
-
Required
By default, no RADIUS scheme is
created.
Required
The defaults are as follows:
0.0.0.0 for the IP address, and
1812 for the port.
Optional
The defaults are as follows:
0.0.0.0 for the IP address, and
1812 for the port.
Remarks
-
Required
By default, no RADIUS scheme is
created.
Required
The defaults are as follows:
0.0.0.0 for the IP address, and
1813 for the port.