3Com MSR 50 Series Configuration Manual page 1446

1446 C 78: MPLS L2VPN C
HAPTER ONFIGURATION
el 100 receive-vpn-label 200
[PE1-POS1/0] quit
3 Configure the P device
<Sysname> system-view
[Sysname] sysname P
[P] interface loopback 0
[P-LoopBack0] ip address 192.4.4.4 32
[P-LoopBack0] quit
# Configure the LSR ID and enable MPLS globally.
[P] mpls lsr-id 192.4.4.4
[P] mpls
# Configure the LSP establishment triggering policy.
[P-mpls] lsp-trigger all
[P-mpls] quit
# Enable LDP globally.
[P] mpls ldp
[P-mpls-ldp] quit
# Configure the interface connected with PE 1, namely POS 1/1, and enable LDP
on the interface.
[P] interface pos 1/1
[P-POS1/1] link-protocol ppp
[P-POS1/1] ip address 10.1.1.2 24
[P-POS1/1] mpls
[P-POS1/1] mpls ldp
[P-POS1/1] quit
# Configure the interface connected with PE 2, namely POS 1/0, and enable LDP
on the interface.
[P] interface pos 1/0
[P-POS1/0] link-protocol ppp
[P-POS1/0] ip address 10.2.2.2 24
[P-POS1/0] mpls
[P-POS1/0] mpls ldp
[P-POS1/0] quit
# Configure OSPF on the P device for establishing LSPs.
[P] ospf
[P-ospf-1] area 0
[P-ospf-1-area-0.0.0.0] network 10.1.1.2 0.0.0.255
[P-ospf-1-area-0.0.0.0] network 10.2.2.2 0.0.0.255
[P-ospf-1-area-0.0.0.0] network 192.4.4.4 0.0.0.0
[P-ospf-1-area-0.0.0.0] quit
[P-ospf-1] quit
4 Configure PE 2