Pl 88.10 Registration/Preheat Assembly (1 Of 2) - Xerox ColorQube 9303 Service Manual

PL 88.10 Registration/Preheat
Assembly (1 of 2)
Item Part Description
1 – Registration/Preheat assembly
(complete) (P/O PL 31.13 Item 7)
(REP 89.1)
2 – Registration scan bar (Q89-005)
(Not spared)
3 – Registration/Preheat pump kit (P/O
PL 31.11 Item 7) (W/O TAG 018)
(REP 89.2)
4 – Rubber mounting (Not spared)
5 – Registration/Preheat air pump
(MOT 88-008) (P/O PL 31.11 Item
7) (REP 89.2)
6 – Rubber mounting (Not spared)
7 – Lower platelet assembly cover (Not
spared)
8 – Pump cover (Not spared)
9 – Sensor cover (Not spared)
10 – Registration/Preheat interface PWB
(Not spared)
11 – Thermal cutout PWB (Not spared)
12 130E12950 Pre transfix sensor (20) (Q89-006)
(REP 10.7)
13 – Lower heat plate (Not spared)
14 – Lower platelet base assembly (Not
spared)
15 – Lower platelet assembly (Not
spared) (REP 89.1)
16 – Frame and jam clearance assembly
(Not spared)
17 – Registration scan bar cover (Not
spared)
18 – Upper heat plate (Not spared)
19 – Idler assembly spring (Not spared)
20 – Idler assembly (Not spared)
21 – Front inverter (Not spared)
22 – Rear inverter (Not spared)
23 – Grounding plate (Not spared)
24 – Upper housing (Not spared)
25 – Shaft (Not spared)
26 – Suction plate (Not spared)
27 – Gear (Not spared)
28 – Shaft (Not spared)
29 – Bearing (Not spared)
30 – Gear (Not spared)
Parts Lists
PL 88.10
November 2015
5-96 Xerox® ColorQube® 9303 Family