REP 8.6 Registration Transport Assembly
Parts List on
PL 2.6
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1.
Remove Rear Cover
(REP
14.2).
2.
Remove Rear Left Upper Cover
(REP
3.
Remove Rear Left Middle Cover
(REP
4.
Close Left Cover Assembly.
5.
Remove Tray 5
(REP
7.1).
6.
Remove Left Cover Assembly
(REP
7.
Remove Registration Transport Assembly
a.
Observe position of harness for later reinstallation.
b.
Remove Screws (2).
c.
Pivot top of Registration Transport out and disconnect Harness.
d.
Lift to remove Registration Transport.
Harness
Screws (2)
Figure 1 Removing Registration Transport Assembly
Initial issue
DC 3535/2240/1632
WARNING
14.5).
14.4).
8.1).
(Figure
1).
Replacement
NOTE: bearing is equipped with two Anti-rotation Tabs. If one breaks during removal, install
bearing so other tab is employed.
NOTE: Check that ground spring is pressing against bronze bushing after installing it.
02/03
4-71
Repairs and Adjustments
REP 8.6