Table of Contents
Advertisement
Package
Table K-1. Absolute Maximum Ratings (VSS = 0V) (continued)
22
Storage Temperature Range
23
Maximum Solder Temperature
24
Moisture Sensitivity Level
1
For internal digital supply of V
2
2.6 volt supply pins can withstand up to 3.6 volts for acumulative time of 24 hours over the lifetime of the device.
3
During operation the value of V
±
4
V
=5.0 V
5%.
DDA
5
All 2.6-V input-only pins are 5-V tolerant.
6
Note that long term reliability may be compromised if 2.6-V output drivers drive a node which has been previously
pulled to >3.1 V by an external component. HRESET and SRESET are fully 5-V compatible.
7
Maximum continuous current on I/O pins provided the overall power dissipation is below the power dissipation of the
package. Proper operation is not guaranteed at this condition.
8
Condition applies to one pin at a time.
9
Transitions within the limit do not affect device reliability or cause permanent damage. Exceeding limit may cause
permanent conversion error on stressed channels and on unstressed channels.
10
Maximum transient current per ISO7637.
11
Maximum operating temperature on any solder ball in outer four rows of solder balls on the package. These rows are
referred to as "Perimeter Balls" to distinguish them from the balls in the center of the package.
12
Solder profile per CDF-AEC-Q100, current revision.
13
Moisture sensitivity per JEDEC test method J-STD-020-A (April 1999).
Functional operating conditions are given in Section K.5, "DC Electrical Characteristics."
Absolute maximum ratings are stress ratings only, and functional operation at the
maximum is not guaranteed. Stress beyond those listed may affect device reliability or
cause permanent damage to the device.
This device contains circuitry protecting against damage due to high static voltage or
electrical fields; however, it is advised that normal precautions be taken to avoid application
of any voltages higher than maximum-rated voltages to this high-impedance circuit.
Reliability of operation is enhanced if unused inputs are tied to an appropriate logic voltage
level (e.g., either V
SS
Negative current flows out of the pin and positive current flows
into the pin.
K.1
Package
The MPC533 is available in packaged form. The package is a 388-ball PBGA having a 1.0
mm ball pitch, Motorola case outline 1164-01 .
K-2
PRELIMINARY—SUBJECT TO CHANGE WITHOUT NOTICE
Rating
12
13
= 2.6-V typical.
DDL
must be 5.0 V
FLASH
or V
).
DD
MPC533 Reference Manual
Symbol
Min. Value
T
-55
STG
T
—
SDR
MSL
—
±
5%
NOTE
Max. Value
Unit
+150
°C
235
°C
3
—
MOTOROLA
Advertisement
Table of Contents
