Table of Contents
Advertisement
13-8
MEASure:<function>? [<rang>], [<res>], [<clist>]
MEASure:VOLTage[:DC]? [<rang>], [<res>], [<clist>]
MEASure:VOLTage:AC? [<rang>], [<res>], [<clist>]
MEASure:CURRent[:DC]? [<rang>], [<res>], [<clist>]
MEASure:CURRent:AC? [<rang>], [<res>], [<clist>]
MEASure:RESistance? [<rang>], [<res>], [<clist>]
MEASure:FRESistance? [<rang>], [<res>], [<clist>]
MEASure:FREQuency? [<rang>], [<res>], [<clist>]
MEASure:PERiod? [<rang>], [<res>], [<clist>]
MEASure:TEMPerature? [<clist>]
MEASure:CONTinuity? [<clist>]
Parameters
Model 2790 SourceMeter
<rang> = Range parameter for the specified function. For example for
DCV, range parameter value 10 selects the 10V range. See the
"NOTES" that follow
<res>
= 0.1
0.01
0.001
0.0001
0.00001
0.000001
The resolution of the <res> parameter value and the selected
range sets the number of display digits. As shown above, with
the 100V range selected and <res> = 0.1, a 100V reading will
be displayed as 100.0 V (3 digits).
The display will default to 3 digits when using parameter
values that attempt to set the display below 3½ digits. For
example, a 10V reading using <res> = 0.1 for the 10V range is
displayed as 10.00 V, not 10.0 V.
A command using parameter values that attempt to set the
display above 7 digits is ignored and generates error -221
(settings conflict error).
See the "NOTES" that follow
information.
<clist> = Single channel only. When included, this is the channel to be
closed and measured.
®
Switch System Reference Manual
Measure DCV
Measure ACV
Measure DCI
Measure ACI
Measure Ω2
Measure Ω4
Measure FREQ
Measure PERIOD
Measure TEMP
Measure CONT
Table 13-1
for additional information.
i.e., 100.0 V (3 digits)
i.e., 10.00 V (3 digits)
i.e., 1.000 V (3 digits)
i.e., 1.0000 V (4 digits)
i.e., 1.00000 V (5 digits)
i.e., 1.000000 V (6 digits)
Table 13-1
for additional
Advertisement
Table of Contents
