Table of Contents
Advertisement
Model 2790 SourceMeter Switch System Reference Manual
Terminator
The Model 2790 can be configured to terminate each program message that it transmits to
the controller with any of the following combinations of <CR> and <LF>.
<CR>
<CR+LF>
<LF>
<LF+CR>
Selecting and configuring RS-232 interface
After selecting (enabling) the RS-232 interface, you will then set the baud rate, flow con-
trol, and terminator.
1.
2.
klqb
3.
4.
5.
Carriage return
Carriage return and line feed
Line feed
Line feed and carriage return
Press the SHIFT key and then the RS-232 key. The RS 232 ON or RS 232 OFF
message will be displayed.
If the RS-232 is already ON, press ENTER and proceed to step 3. Otherwise, press
the
key to place the cursor on OFF, press the
state, and then press ENTER.
Enabling (ON) the RS-232 interface disables (OFF) the GPIB. Disabling the
RS-232 interface enables the GPIB.
To retain the presently displayed BAUD rate, press ENTER and proceed to step 4.
Otherwise, press the
or
key to display the desired baud rate, and then press ENTER.
To retain the presently displayed FLOW control, press ENTER and proceed to step 5.
Otherwise, press the
or
key to display the alternate flow control setting, and then press ENTER.
To retain the presently displayed terminator (Tx TERM), press ENTER. Otherwise,
press the
key to place the cursor on the terminator setting, use the
to display the desired terminator, and then press ENTER.
key to place the cursor on the baud rate value, use the
key to place the cursor on the flow control setting, use the
or
key to display the ON
or
10-19
key
Advertisement
Table of Contents
