Table of Contents
Advertisement
15-2
Reference tables
Table 15-1
Model 7751, 7752, and 7702 switching modules.
klqb
Table 15-1
Table 15-2
Table 15-3
Table 15-4
Table 15-5
Table 15-6
Table 15-7
Table 15-8
Table 15-9
Table 15-10
Table 15-11
General notes:
•
•
•
•
•
•
•
•
through
Table 15-11
The <clist> parameters listed in the following tables are used to configure scan
channels of a 7702 switching module.
— CALCulate command summary
— DISPlay command summary
— FORMat command summary
— ROUTe command summary
— SENSe command summary
— SOURce command summary
— STATus command summary
— SYSTem command summary
— TRACe command summary
— Trigger command summary
— UNIT command summary
Brackets ([ ]) are used to denote optional character sets. These optional characters
do not have to be included in the program message. Do not use brackets in the pro-
gram message.
Angle brackets (< >) are used to indicate parameter type. Do not use angle brackets
in the program message.
The Boolean parameter (<b>) is used to enable or disable an instrument operation.
1 or ON enables the operation and 0 or OFF disables the operation.
Upper case characters indicate the short-form version for each command word.
Default Parameter — Listed parameters are both the *RST and SYSTem:PRESet
defaults, unless noted otherwise. Parameter notes are located at the end of each
table.
Ref — The reference column indicates where to find detailed information on the
command(s).
SCPI — A checkmark (✓) indicates that the command and its parameters are SCPI
confirmed. An unmarked command indicates that it is a SCPI command, but does
not conform to the SCPI standard set of commands. It is not a recognized
command by the SCPI consortium. SCPI confirmed commands that use one or
more non-SCPI parameters are explained by notes.
CALCulate, SENSe, and UNIT subsystem commands associated with DCV, 2-wire
ohms, and 4-wire ohms functions can use optional Mn parameter in <clist> with
memory patterns (firmware A04 and higher). See
Model 2790 SourceMeter
summarize the commands to operate the Model 2790 and
®
Switch System Reference Manual
"Memory patterns," page
2-36.
Advertisement
Table of Contents
