Table of Contents
Advertisement
Model 2790 SourceMeter® Switch System Reference Manual
Table 15-8
SYSTem command summary
Command
SYSTem
:PRESet
:POSetup <name>
:POSetup?
:FRSWitch?
:BEEPer
[:STATe] <b>
[:STATe]?
:KCLick <b>
:KCLick?
:KEY <NRf>
:KEY?
:AZERo
:STATe <b>
:STATe?
:LSYNc
[:STATe] <b>
[:STATe]?
:LFRequency?
:PCARdX <name>
:CARDX
:SNUMber?
:SWRevision?
:VMAX?
:MUX?
:ISOLated?
:TCOMpensated?
:VCHannel
[:STARt]?
:END?
Description
Return to :SYST:PRES defaults.
Select power-on setup (RST, PRESet).
Query power-on setup.
Query INPUTS switch (0=rear, 1=front).
Path to control beeper.
Enable or disable beeper.
Query state of beeper.
Turn the keyclick on/off.
Query the keyclick status.
Simulate key-press (1 to 31; see
Query the last "pressed" key.
Path to set up autozero.
Enable or disable autozero.
Query autozero.
Path to control line synchronization:
Enable or disable line-sync.
Query state of line-sync.
Query power line frequency.
Set up an empty slot (X = 1 or 2) as a pseudocard
(C7702, C7751, C7752).
Path to query switching module in specified slot
(X = 1 or 2).
Request serial number
Request firmware revision
Request maximum allowable voltage.
Support multiplexer channels?; 1 = yes, 0 = no.
Support isolated channels?; 1 = yes, 0 = no.
Built-in temperature sensors for T/C cold
junction?; 1 = yes, 0 = no
Path to query volts/2-wire channels:
Request lowest numbered volts/2-wire channel
(usually 1); 0 = voltage measurements not
supported.
Request highest numbered volts/2-wire channel.
0 = voltage measurements not supported.
Figure
14-3).
2
.
2
.
3
.
Default
parameter
Ref
Sec 1
PRES
Sec 1
Sec 1
Sec 14
ON
ON
Sec 1
Sec 14
Sec 3
ON
Sec 3
OFF
Sec 1
Sec 2
1
15-21
SCPI
✓
✓
✓
✓
✓
Advertisement
Table of Contents
