Table of Contents
Advertisement
1-24
Remote programming information
Remote programming information is integrated with front panel operation throughout
this manual. Programming commands are listed in tables, and additional information that
pertains exclusively to remote operation is provided after each table. The tables may
reference you to other sections of this manual.
klqb
Optional command words — In order to be in conformance with the IEEE-488.2 stan-
dard, Model 2790 accepts optional command words. Any command word that is enclosed
in brackets ([]) is optional and does not have to be included in the program message.
Query commands — Most command words have a query form. A query command is
identified by the question mark (?) that follows the command word. A query command
requests (queries) the programmed status of that command. When a query command is
sent and Model 2790 is addressed to talk, the response message is sent to the computer.
klqb
Quick start exercises (QS3)
This section topic summarizes the following basic instrument operations and provides
simple exercises to perform them:
•
•
•
•
t^okfkd
klqb
Except for
Section 11
ual are abridged. That is, they exclude most optional command words and query
commands. Optional command words and query commands are summarized as
follows.
For complete details, see
Basic DMM measurements — front panel inputs.
Closing and opening channels — Models 7751, 7752, 7753, and 7702.
Simple scanning — Model 7702 only.
Trigger and return readings — remote programming.
For the exercises, it is not necessary to connect an input signal or DUT
to the instrument (front panel inputs or switching module inputs).
However, if you decide to use an input signal, it is recommended that
you keep it at a nonhazardous level (<42V) while learning to use the
instrument. When testing airbags, do connect any external sources to
the test system.
When using the front panel input terminals, the INPUT switch must be in the
"F" (out) position. The INPUT switch is located on the right side of the front
panel near the input terminals. When using a switching module, the switch must
be in the "R" (in) position.
Model 2790 SourceMeter
through
Section
15, most programming tables in this man-
"Programming syntax," page
®
Switch System Reference Manual
10-10.
Advertisement
Table of Contents
