Keithley SourceMeter 2790 Reference Manual page 362

Model 2790 SourceMeter® Switch System Reference Manual
Table 15-4
ROUTe command summary
Command
ROUTe
:MONitor <clist>
:STATe <b>
:STATe?
:DATA?
:POINts <NRf>
:POINts?
:MONitor?
:CLOSe <clist>
:STATe? <clist>
:ACONfigure <b>
:ACONfigure?
:COUNt? <clist>
:INTerval <NRf>
:INTerval?
:CLOSe?
:OPEN:ALL
:MULTiple
:OPEN <clist>
:CLOSe <clist>
:STATe? <clist>
:CLOSe?
Notes:
1. Default value depends on which switching module is installed.
2. Not affected by *RST and SYSTem:PRESet. Front panel factory default is OFF.
3. Not affected by *RST and SYSTem:PRESet. Interval set to 15 minutes at the factory.
4. Memory patterns available in firmware revision A04 and higher. 40 memory locations available.
5. Memory pattern locations not affected by *RST or SYSTtem:PRESet. Use ROUT:MEM:CLE to clear memory.
Description
Specify one channel to be monitored
(7702 only).
Enable or disable channel monitoring.
Query state of channel monitoring.
Returns the most recent monitor reading.
For a monitor scan, specify number of
channels to scan (2 to 55000).
For a monitor scan, query number of
channels to scan.
Query the channel to be monitored.
Close the one specified 7702 channel (all
others will open).
Query closed channels in specified list;
1 = closed.
Enable or disable auto-configure.
Query state of auto-configure.
Query closure count for specified
channels.
Set count update interval in minutes
(10 to 1440).
Query relay count update interval.
Returns a <clist> of closed channels.
Open all channels.
Path to control multiple channels:
Open channel(s) specified in list.
Unlisted channels not affected.
Close channel(s) specified in list.
Unlisted channels not affected.
Query closed channels in specified list;
1 = closed.
Return list of all closed channels.
15-7
Default
parameter Ref SCPI
Sec 7
OFF
(Note 1)
Sec 2
(Note 2)
Sec 2
(Note 3)
Sec 2
Sec 2