Table of Contents
Advertisement
Model 2790 SourceMeter
Power-up (QS2)
Line power connection
Follow the procedure below to connect the Model 2790 to line power and turn on the
instrument.
1.
`^rqflk
2.
Figure 1-3
Power module
WARNING:
DIGITAL I/O
TRIG. LINK
!
SLOT COVER
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
3.
®
Switch System Reference Manual
Check to see that the line voltage indicated in the window of the fuse holder assem-
bly
(Figure
1-3) is correct for the operating voltage in your area. If not, refer to
"Setting line voltage and replacing fuse," page
Operating the instrument on an incorrect line voltage may cause
damage to the instrument, possibly voiding the warranty.
Before plugging in the power cord, make sure that the front panel power switch is
in the off (O) position.
Model 2790
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
RS232
IEEE-488
MADE IN
U.S.A.
KEITHLEY
Connect the female end of the supplied power cord to the AC receptacle on the rear
panel. Connect the other end of the power cord to a grounded AC outlet.
1-14.
!
SLT
1
Line
SLT
2
Voltage
Selector
Fuse
Spring
Window
Fuse Holder Assembly
1-13
Advertisement
Table of Contents
