Table of Contents
Advertisement
Model 2790 SourceMeter
Event registers
As
Figure 11-1
the appropriate event register bit sets to 1. The bit remains latched to 1 until the register is
reset. Reading an event register clears the bits of that register. *CLS resets all four event
registers.
The commands to read the event registers are listed in
registers, see
Table 11-4
Event register commands
*ESR?
STATus:OPERation:[:EVENt]?
STATus:MEASurement:[:EVENt]?
STATus:QUEStionable:[:EVENt]?
Note: Power-up and *CLS resets all bits of all event registers to 0. STATus:PRESet has no effect.
®
Switch System Reference Manual
shows, each status register set has an event register. When an event occurs,
"Reading registers," page
Command
Table
11-4. For details on reading
11-6.
Description
Read Standard Event Status Register.
Read Operation Event Register.
Read Measurement Event Register.
Read Questionable Event Register.
11-19
Advertisement
Table of Contents
