Keithley SourceMeter 2790 Reference Manual page 454

Hide thumbs Also See for SourceMeter 2790:

Table of Contents

Model 2790 SourceMeter

Model 7751/7752/7753 fuses

Switch System Reference Manual

Do not use a fuse with a higher current rating than specified or

inadvertent detonation of the airbag being tested may occur.

Solder the new fuse in place using organic (OA based) flux solder, again taking

care not to damage the circuit board or spread solder flux around the board.

Carefully clean the repaired area of the circuit board with a foam tipped swab or

brush dipped in pure water, then blow-dry the board with dry nitrogen gas. Allow

the board to dry for several hours in a 50°C low-humidity environment before use.

Re-install the circuit board into the plastic housing, then close the top cover.

SOURCE SENSE