Table of Contents
Advertisement
Model 2790 SourceMeter
Scanning commands
Scanning commands are listed in
follow the table.
klqb
Table 7-1
Scanning commands
Commands
Scan commands
ROUTe:SCAN <clist>
ROUTe:SCAN?
ROUTe:SCAN:TSOurce <list>
ROUTe:SCAN:NVOLatile <b>
ROUTe:SCAN:LSELect <name> Enable/disable scan; <name> = INTernal (on) or NONE
ROUTe:MONitor <clist>
ROUTe:MONitor:POINts <NRf> Specify number of channels to scan; <NRf> = 2 to
ROUTe:MONitor:STATe <b>
ROUTe:MONitor:DATA?
ROUTe:CLOSe:ACONfigure <b> Enable or disable auto channel configuration.
Limits commands
CALCulate3:LIMit1:UPPer <n>
CALCulate3:LIMit1:LOWer <n> Set low limit 1 for monitor; <n> = -4294967295 to
CALCulate3:LIMit2:UPPer <n>
CALCulate3:LIMit2:LOWer <n> Set low limit 2 for monitor; <n> = -4294967295 to
CALCulate3:LIMit1:STATe <b>
CALCulate3:LIMit2:STATe <b>
®
Switch System Reference Manual
Memory pattern commands, queries, and optional command words are not
included in
Table
7-1. The unabridged SCPI tables are provided in
Memory pattern commands are listed in
Specify list of channels to be scanned.
Returns list of channels to be scanned.
Select trigger(s) to start scan: <list> = IMMediate, or
HLIMit1, LLIMit1, HLIMit2, LLIMit2.
Enable or disable auto scan; <b> = ON or OFF.
(off).
Specify one channel to be monitored.
55000.
Enable/disable monitor; <b> = ON or OFF.
Returns the most recent monitor reading.
Set high limit 1 for monitor; <n> = -4294967295 to
+4294967295.
+4294967295.
Set high limit 2 for monitor; <n> = -4294967295 to
+4294967295.
+4294967295.
Enable/disable limit 1 test; <b> = ON or OFF.
Enable/disable limit 2 test; <b> = ON or OFF.
Table
7-1. Additional information on these commands
Table 2-4
Description
Section
and in
Table
15-4.
Default Ref
IMM
(Note 1)
NONE
(Note 3)
OFF
1.0
-1.0
2.0
-2.0
OFF
OFF
7-29
15.
a
b
c
d
Advertisement
Table of Contents
