Table of Contents
Advertisement
Model 2790 SourceMeter
Table 5-1 (cont.)
Rel commands
Commands
Rel commands for Ω2
[SENSe[1]]
:RESistance:REFerence <n> [, <clist>]
:RESistance:REFerence:STATe <b> [, <clist>]
:RESistance:REFerence:ACQuire [, <clist>]
Rel commands for Ω4
[SENSe[1]]
:FRESistance:REFerence <n> [, <clist>]
:FRESistance:REFerence:STATe <b> [, <clist>]
:FRESistance:REFerence:ACQuire [, <clist>]
Rel commands for TEMP
[SENSe[1]]
:TEMPerature:REFerence <n> [, <clist>]
:TEMPerature:REFerence:STATe <b> [, <clist>]
:TEMPerature:REFerence:ACQuire [, <clist>]
Rel commands for FREQ
[SENSe[1]]
:FREQuency:REFerence <n> [, <clist>]
:FREQuency:REFerence:STATe <b> [, <clist>]
:FREQuency:REFerence:ACQuire [, <clist>]
Rel commands for PERIOD
[SENSe[1]]
:PERiod:REFerence <n> [, <clist>]
:PERiod:REFerence:STATe <b> [, <clist>]
:PERiod:REFerence:ACQuire [, <clist>]
Channel list parameter:
7702 <clist> = (@SCH)
where: S
= Mainframe slot number (1 or 2)
CH = Switching module channel number (must be 2 digits)
7751/7752/7753 <clist> (DCV, Ω2, Ω4) = (@Mn) (see
1. The <clist> parameter is used to configure one or more channels for a scan. Each channel in the <clist> must be set to the function
specified by the rel (reference) command. If not, a conflict error (-221) will occur. For example, VOLTage:AC:REFerence 1,
(@101) is only valid if scan channel 101 is set for the ACV function.
2. [:DC] is optional for the commands to set DCV and DCI rel.
®
Switch System Reference Manual
1
2
Description
Optional root command.
Specify rel value; <n> = 0 to 120e6 (Ω).
Enable/disable rel; <b> = ON or OFF.
Use input signal as rel value.
Optional root command.
Specify rel value; <n> = 0 to 120e6 (Ω).
Enable/disable rel; <b> = ON or OFF.
Use input signal as rel value.
Optional root command.
Specify rel value; <n> = -200 to 1820 (°C). 0
Enable/disable rel; <b> = ON or OFF.
Use input signal as rel value.
Optional root command.
Specify rel value; <n> = 0 to 1.5e7 (Hz).
Enable/disable rel; <b> = ON or OFF.
Use input signal as rel value.
Optional root command.
Specify rel value; <n> = 0 to 1 (sec).
Enable/disable rel; <b> = ON or OFF.
Use input signal as rel value.
"Memory patterns," page
5-5
Default
0
OFF
0
OFF
OFF
0
OFF
0
OFF
2-36).
Advertisement
Table of Contents
