Table of Contents
Advertisement
Model 2790 SourceMeter® Switch System Reference Manual
Table 15-8 (cont.)
SYSTem command summary
Command
SYSTem
:TIME <hr, min,
sec>
:TIME?
:DATE <yr, mo,
day>
:DATE?
:TSTamp
:TYPE <name>
:TYPE?
:RELative
:RESet
:RNUMber
:RESet
:ERRor?
:CLEar
:VERSion?
:LOCal
:REMote
:RWLock
Note:
1. If there is no card in the specified slot, error -241 Hardware Missing will occur.
2. If a pseudocard is installed in the slot, the message "????????" will be returned when querying the serial number or firmware
revision.
3. These commands are not useful to Model 2790 users since none of the relevant modules are supported by the Model 2790 main-
frame. They are included to provide compatibility with the software that also supports the 2700/2750. Future modules for the
Model 2790 may use these commands.
4. Power-up and *CLS clears the error queue.*RST, SYSTem:PRESet, and STATus:PRESet have no effect on the error queue.
Description
Set system time using 24-hour format.
Query system time.
Set system date (yr = 2002 to 2101).
Query system date.
Path to set timestamp:
Select timestamp type (RELative or RTCLock).
Query timestamp type that will be used for the
next buffer storage.
Path to reset relative timestamp:
Reset relative timestamp to 0.
Path to reset reading number:
Reset reading number. Next reading will be #1.
Query (read) Error Queue.
Clears messages from the Error Queue.
Query rev level of SCPI standard.
Take Model 2790 out of remote and restore opera-
tion of front panel controls (RS-232 only).
Place Model 2790 in remote (RS-232 only).
Lockout front panel controls (RS-232 only).
15-23
Default
parameter
Ref
SCPI
Sec 6
Sec 6
Sec 6
REL
Sec 14
(Note 4)
Sec 11
Sec 11
Sec 14
Sec 10
Sec 10
Sec 10
✓
✓
Advertisement
Table of Contents
