Table of Contents
Advertisement
11-4
Clearing registers and queues
When the Model 2790 is turned on, the bits of all registers in the status structure are
cleared (reset to 0), and the two queues are empty. Commands to reset the event register
and event enable register and the Error Queue are listed in
commands, any enable register can be reset by sending the 0 parameter value with the
individual command to program the register.
klqb
Table 11-1
Common and SCPI commands to reset registers and clear queues
*CLS
STATus:PRESet
Clear error queue
*CLS
STATus:QUEue:CLEar
SYSTem:CLEar
Notes:
1. The Standard Event Enable Register is not reset by STATus:PRESet or *CLS. Send the 0 parameter value
with *ESE to reset all bits of that enable register to 0 (see
page
2. STATus:PRESet has no effect on the Error Queue.
3. Use either of the two clear commands to clear the Error Queue.
SYSTem:PRESet and *RST have no effect on status structure registers and
queues.
Commands
Reset registers
Reset all bits of the following event registers to 0:
Reset all bits of the following enable registers to 0:
Clear all messages from Error Queue
Clear messages from Error Queue
Clear messages from Error Queue
11-9).
Model 2790 SourceMeter
Description
Standard Event Register
Operation Event Register
Measurement Event Register
Questionable Event Register
Operation Event Enable Register
Measurement Event Enable Register
Questionable Event Enable Register
"Status byte and service request commands,"
®
Switch System Reference Manual
Table
11-1. In addition to these
Notes
1
1
2
3
3
Advertisement
Table of Contents
