Verifying The Power Supply And Fuse; Changing The Voltage Setting Or Fuse - Thermo Scientific Evolution 200 Series User Manual

Verifying the Power Supply and Fuse

Thermo Scientific
• Verifying the Power Supply and Fuse
•

Changing the Voltage Setting or Fuse

NOTICE The unit is factory set to operate at 220 V.
For operation at 120 V, configure the voltage selector on the Peltier back panel and insert the
correct fuse as described in the following table.
Power Supply Type of fuse - 250 V
240 V T 1A, Slo Blo
120 V T 2A, Slo Blo
Adjustment for frequency change between 50 and 60 Hz is not necessary.
Related Topics
Changing the Voltage Setting or Fuse
General Safety Information
Preinstallation
Installation
Operation
Maintenance
Troubleshooting
Voltage display window
Fuse drawer tab
Peltier Thermostatted Single Cell Holder
Evolution 200 Series User Guide
20
317