Operation - Thermo Scientific Evolution 200 Series User Manual

31
VERSA Probe
Installing Tips

Operation

446 Evolution 200 Series User Guide
Installation
Tips must be installed to take measurements.
Release button
Pin
To install a tip
1. Slide a quartz tip onto the probe shaft.
2. Align the notch at the base of the tip with the pin on the probe handle.
3. Press and hold the release button and slide the notch under the pin.
4. Release the button.
Verify the tip is secure by touching the middle portion of the tip and gently attempting to
slide it. If the tip is secure, it will not move.
To remove the tip
Press the release button.
Related Topics
Installing the VERSA Probe
Installation
Install a tip before using the probe. See
When inserting the probe into a solution, shake the probe gently to release any air bubbles
trapped in the probe tip.
Notch
Quartz tip
Shaft
Installing Tips.
Thermo Scientific