Thermo Scientific Evolution 200 Series User Manual page 104

2
INSIGHT Software
Operation
90 Evolution 200 Series User Guide
The selected spectrum appears in the Operands pane.
The workbook spectra are listed at the left. To add others:
a. Click Browse.
b. Select a folder in the left pane (use the features above it to navigate), a workbook in
the middle pane, and spectra in the upper-right pane. To select multiple spectra, hold
down Shift or Ctrl. Selected spectra appear in the lower-right pane.
c. Click OK. Each added spectrum is listed with asterisks at the beginning of its name
to indicate the data is not in the current workbook.
2. Select any other listed spectra to operate on and click Add.
To remove a spectrum from the Operands pane, click it and click Remove. To remove all
the spectra, click Clear All.
3. Select the arithmetic operation to perform on the Y value of every data point.
4. Specify the factor: type a value, click the up and down arrow buttons, or drag the slider.
5. To perform a math operation on the result, click Operate on Result and choose an
operation. Otherwise, go to the next step.
Note To use the result in another Factor operation, use Workbook or Temporary to
add it to the list (see step 6), click Add to make it an operand, and continue with step
2.
Perform the operation as explained in the appropriate related topic below.
To return to the previous window, click Back.
To perform additional math operations, repeat this step.
6. To save the result in the current workbook, click Workbook and name the spectrum or
spectra when prompted.
The data is added to the list and is available for operations.
To add the result to the list without saving it, click Temporary. Asterisks at the beginning
of a spectrum name indicate the data is not saved.
Thermo Scientific