Installation - Thermo Scientific Evolution 200 Series User Manual

Installation

Thermo Scientific
9. Replace the fuse with a new one that is appropriate for the selected voltage. See Verifying
the Power Supply and Fuse.
10. Slide the fuse drawer back into the fuse compartment until it locks in place.
11. Connect the power cord to the wall outlet.
12. Turn on the main power switch on the Peltier unit back panel.
If the unit does not perform normally or if the replacement fuse blows, contact technical
support.
Related Topics
Verifying the Power Supply and Fuse
General Safety Information
Preinstallation
Installation
Operation
Maintenance
Troubleshooting
Before powering on the Peltier recirculator:
• Check the power supply voltage setting and fuse. See
Fuse.
• Connect the recirculator to a thermostatted accessory and fill the reservoir.
NOTICE The recirculator is filled with distilled water before shipment. During
installation, when connecting the tubing, the water level in the reservoir will drop and
must be refilled before use. Use only distilled water to refill the reservoir. A refill bottle is
provided for this purpose. See
Before starting the recirculator, familiarize yourself with the software features described in
Operation.
To install the recirculator
1. Position the recirculator in a suitable location.
NOTICE Leave at least 5 cm (2 in) in front and back of the unit for air circulation.
Filling the Reservoir.
TPS-1500W Sealed Peltier Recirculator
Verifying the Power Supply and
Evolution 200 Series User Guide
19
299