Thermo Scientific Evolution 200 Series User Manual page 340

20
Peltier Thermostatted Single Cell Holder
Table 4. Startup modes and button functions
Page Mode
Startup Standby
Normal
Alarm
*Only if the manual alarm reset option has been configured
Table 5. Normal Mode functions
Page Display
Change Set Flashing selected
Point parameter
Main Menu Parameter
Configure
Diagnostic
326 Evolution 200 Series User Guide
Display
Standby
Actual block temperature
Block Set temperature
Stirring speed (left)
Heating/cooling power (right)
Alarm description
Standby Mode
• Press and hold the Center button for one to two seconds to proceed to Normal Mode.
Normal Mode
Button Functions
• Press the Left button to go to the Main Menu page.
• Press the Right button to go to the Change Set Point page.
• Press and hold the Center button for one to two seconds to return to Stand-By Mode.
• From the Startup page in Normal Mode, use the Change button to move about the
screen.
Description
Change Temperature or
Stirring Speed Set Point
User Parameters
Configuration Parameters
Diagnostic Values
Changing the set temperature
1. Highlight Set Temperature.
The Change Set Point page is displayed with down and up arrows above the Left and
Center buttons.
Left button Center button
On
Menu Off
(Go to Main
Menu)
Menu Beep on/off
Left button
Down
Scroll
Scroll
Down
Right button
Change (Go to
Change Set Point
Page)
Reset alarm/change*
Center button Right button
Up Change
Select Exit
Up Exit
Up Exit
Thermo Scientific