Igmp-Snooping General-Query Source-Ip - HP 3600 v2 Series Command Reference Manual

Description
Use igmp-snooping fast-leave to enable fast-leave processing on the current port or group of ports. With
this function enabled, when the switch receives an IGMP leave message on a port, it directly removes that
port from the multicast forwarding entry of the specific group.
Use undo igmp-snooping fast-leave to disable fast-leave processing on the current port or group of ports.
By default, fast-leave processing is disabled.
For the HP 3600 v2 EI switches, this command takes effect in both IGMP snooping-enabled VLANs and
VLANs with IGMP enabled on their VLAN interfaces.
For the HP 3600 v2 SI switches, this command takes effect in IGMP snooping-enabled VLANs.
If you do not specify any VLAN when using this command in Layer 2 Ethernet interface view or Layer 2
aggregate interface view, the command takes effect for all VLANs that the interface belongs to. If you
specify one or more VLANs, the command takes effect for the specified VLANs that the interface belongs
to.
If you do not specify any VLAN when using this command in port group view, the command takes effect
on all the ports in this group. If you specify one or more VLANs, the command takes effect only on those
ports in this group that belong to the specified VLANs.
Related commands: fast-leave.
Examples
# Enable fast-leave processing on Ethernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] igmp-snooping fast-leave vlan 2

igmp-snooping general-query source-ip

Syntax
igmp-snooping general-query source-ip { ip-address | current-interface }
undo igmp-snooping general-query source-ip
View
VLAN view
Default level
2: System level
Parameters
ip-address: Specifies the source address of IGMP general queries, which can be any legal IP address.
current-interface: Sets the source address of IGMP general queries to the address of the current VLAN
interface. If the current VLAN interface does not have an IP address, the default IP address 0.0.0.0 is
used as the source IP address of IGMP general queries.
Description
Use igmp-snooping general-query source-ip to configure the source address of IGMP general queries.
Use undo igmp-snooping general-query source-ip to restore the default.
By default, the source IP address of IGMP general queries is 0.0.0.0.
15