YASKAWA iQpump1000 User Manual page 490

D.1 European Standards
Drive Model
<1>
5A0062
<1>
5A0077
<1>
5A0099
<1>
5A0125
<1>
5A0145
<1>
5A0192
<1>
5A0242
<1> 600 V class drives are not compliant with European Standards.
n Guarding Against Harmful Materials
When installing IP00/Open Type enclosure drives, use an enclosure that prevents foreign material from entering the drive
from above or below.
n Grounding
The drive is designed to be used in T-N (grounded neutral point) networks. If installing the drive in other types of grounded
systems, contact your Yaskawa representative for instructions.
u
EMC Guidelines Compliance
This drive is tested according to European standards IEC/EN 61800-3: 2004.
n
EMC Filter Installation
The following conditions must be met to ensure continued compliance with guidelines.
for EMC filter selection.
Installation Method
Verify the following installation conditions to ensure that other devices and machinery used in combination with this drive
also comply with EMC guidelines.
1.
Install an EMC noise filter to the input side specified by Yaskawa for compliance with European standards.
2.
Place the drive and EMC noise filter in the same enclosure.
3.
Use braided shield cable for the drive and motor wiring, or run the wiring through a metal conduit.
4.
Keep wiring as short as possible. Ground the shield on both the drive side and the motor side.
A – Drive
B – 10 m max cable length between
C – Motor
5.
Make sure the protective earthing conductor complies with technical standards and local safety regulations.
490
Model
FWP-250A
FWP-250A
FWP-250A
FWP-350A
FWP-350A
FWP-600A
FWP-600A
A
drive and motor
Figure D.2 Installation Method
Fuse Type
Manufacturer: Bussmann
B
C
D
U/T1 U
V/T2 V
M
W/T3 W
E
D – Metal conduit
E – Ground wire should be as short as
possible.
YASKAWA TOEP YAIP1W 01F YASKAWA AC Drive - iQpump1000 User Manual
Fuse Ampere Rating (A)
250
250
250
350
350
600
600
Refer to EMC Filters on page 493